![]() ![]() Fit the swan neck pipes shown in Fig: 3.Ĥ. Remove the delivery valve spring, peg, and refit the delivery valve holder. Remove the 1st cylinder high-pressure pipe and the delivery valve holder after loosening the holder clamp. ![]() Temporarily fix fuel shut off rod in this position and proceed with fuel injection timing as shown in Fig: 2.ģ. Now slowly rotate the engine clockwise to the point where the timing pin goes fully into the first hole in the flywheel and slides easily.Īfter removing the inspection cover, pull the fuel shut off rod to the point where the control rod quadrant is visible and slightly forward of the middle position. When the ‘O’ mark on pump gear and intermediate gear teeth are about little away from meshing, insert the longer end of the timing pin in the flywheel housing as shown in Fig: 1. Rotate the engine clockwise and observe the ‘O’ mark on the fuel injection pump gear teeth. Remove the timing gear inspection cover and the timing pin from the flywheel housing.Ģ. Accurate fuel injection timing is set by fuel-cut-off method using swan neck pipe on number 1 delivery valve holder after removing the delivery valve spring and peg.ġ. ![]()
0 Comments
|
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
March 2023
Categories |